When your roller door is not working as it should, it is time to call a repair service. The problem is usually the result of excessive dirt and humidity. However, it can also be caused by misaligned panels or broken springs. The good news is that there are several easy solutions to these problems. Read on to learn more about how to fix your roller door.
When it comes to Roller Door Repair South Australia, there are several things that you can do yourself. The first step is to unscrew the rollers and panels. You can then unscrew the hinges that hold the panels in place, and you can also unscrew the brackets that hold the rollers in place. Make sure to tape over any window areas, too.
Consider adjusting the tension of the springs. You can do this by using a socket wrench or drill. In the case of torsion springs, you can also use an open-ended wrench or a spanner to adjust the tension. Again, using the right tool can save you a lot of time.
Dirt, dust, and humidity are culprits.
If your roller door is hard to open or close, there’s a good chance that it’s not in alignment. It can be caused by a jammed spring or friendly guides. It may also be the result of high spring tension. Sometimes, damaged doors can be confused with misaligned tracks, so it’s crucial to find out the real cause. For example, a jammed door may be obstructed by dirt, dust, or other debris that has built up over time.
A loose track or a bent guide can also cause an off-track roller door. The track or guide should be tightened or cleaned. If this fails, you can disconnect the door from its opener and readjust the guides until they are plumb. When re-installing the door, ensure the gap and guide dimensions match the instructions in the installation manual. If the guides are bent or damaged, it’s best to have a professional handle the Roller Door Repair South Australia.
Misaligned panels
A misaligned roller door can make it difficult to close or open. It may also cause paint to peel off the panels. If you suspect a misaligned roller door, you should have it checked by a professional immediately. The best way to diagnose the problem is by inspecting each part individually.
Broken springs
Broken springs are one of the most common problems for roller doors. Fortunately, a broken spring can be easily replaced. You can order a replacement spring directly from the manufacturer or purchase one on the secondary market. In either case, you must be sure to get the correct type and size of spring for your roller door. Also, ensure that the new spring has the proper length and follow the manufacturer’s installation instructions.
The main problem with broken springs is that they don’t have the strength to handle daily use. So even if they’re made to last for many years, they’ll eventually break due to wear and tear. Thankfully, you can have them repaired by a professional.
Out-of-balance/off-track correction
The first step in the out-of-balance/off-track correction for the roller doors repair process is visually inspecting the door. First, check whether it opens and closes on its own. You can gain access to the torsion rod and tension spring adjuster if it does. These are usually located on the outer edge of the spring.
Next, check the rollers to see if they are operating smoothly. You can also manually test the door to determine if the track is not aligned correctly. If so, use locking pliers or vice grips to hold the door in place while you align the track. If this doesn’t work, you can call a professional.
Panel repair
A bent panel may be easily fixed by applying aluminium foil to it. It can then be straightened with heat or compressed air. The process should only take a few minutes.